The function of return pin
Push the ejecting plate back
The Spec. of return pin
Usually, when production automation is required for the plastic injection mold, a spring has to be installed under RP. See the following diagram: The spring type is TF. (Note: spring installation requirements: A. Spring preload is set between 5 – 10mm in the pre-action status. B. Spring preload is set to be over 10mm when return is first needed.
The material of return pin
SUJ2,Hardness HRC60°(High frequency quenching)
Related Industry Knowledge
- Plastic Mould
- Introduction to Plastic Mould
- Main classification of plastic moulds
- Structural elements of plastic moulds
- Material requirements for plastic m...
- Material selection of plastic mould
- Technical application of plastic mould
- Mold Development
- Injection mould
- The composition of the mould
- What is the ejector block in plasti...
- How to improve the heat treatment d...
- General knowledge of stamping safety
- The steels for plastic injection mold
- What size mold manufacturer is a go...
- Inspections of moulds and tools in ...
- FAQ for Aoxu Mould Technology.
- China Compression Moulds Manufacturer
- Two Types of SMC /BMC moulds
- Moldflow Analysis