Casting is a simple, inexpensive and versatile way of forming aluminum into a wide array of products. Such items as power transmissions and car engines and the cap atop the Washington Monument were all produced through the aluminum casting process. Most castings, especially large aluminum products, are usually made in sand molds.
Casting must include a part-removal design
Casting molds must be designed to accommodate each stage of the process. For part removal, a slight taper (known as draft) must be used on surfaces perpendicular to the parting line so the pattern can be removed from the mold.
Casting parts with cavities
To produce cavities within castings (such as for engine blocks and cylinder heads used in cars), negative forms are used to make cores. Casts of this nature are usually produced in sand molds. Cores are inserted into the casting box after the pattern is removed.
Casting for light weight and strength
Aluminum’s properties of light weight and strength bring fundamental advantages when cast into parts. One common application of die cast aluminum is thin-walled enclosures with ribs and bosses on the interior to maximize strength.
Casting in the early history of aluminum
The first commercial aluminum products were castings such as decorative parts and cookware. Though produced through a centuries-old process, these products were considered new and unique.
The process of casting aluminum
Casting is the original and most widely used method of forming aluminum into products. Technical advances have been made, but the principle remains the same: Molten aluminum is poured into a mold to duplicate a desired pattern. The three most important methods are die casting, permanent mold casting and sand casting.
The die casting process forces molten aluminum into a steel die (mold) under pressure. This manufacturing technique is normally used for high-volume production. Precisely formed aluminum parts requiring a minimum of machining and finishing can be produced through this casting method.
Permanent mold casting
Permanent mold casting involves molds and cores of steel or other metal. Molten aluminum is usually poured into the mold, although a vacuum is sometimes applied. Permanent mold castings can be made stronger than either die or sand castings. Semi-permanent mold casting techniques are used when permanent cores would be impossible to remove from the finished part.
The most versatile method for producing aluminum products is sand casting. The process starts with a pattern that is a replica of the finished casting. Virtually any pattern can be pressed into a fine sand mixture to form the mold into which the aluminum is poured. The pattern is slightly larger than the part to be made, to allow for aluminum shrinkage during solidification and cooling. As compared to die and permanent mold casting, sand casting is slow process but usually more economical for small quantities, intricate designs or when a very large casting is required.
Widespread use in the automotive industry and homes
The automotive industry is the largest market for aluminum casting. Cast products make up more than half of the aluminum used in cars. Cast aluminum transmission housings and pistons have been commonly used in cars and trucks since the early 1900s. Parts of small appliances, hand tools, lawnmowers and other machinery are produced from thousands of different unique aluminum casting shapes. The casting product most often used by consumers is cookware, the first aluminum product that was made available for everyday use.
Posted by Leila.
Related Industry Knowledge
- Plastic Mould
- Introduction to Plastic Mould
- Main classification of plastic moulds
- Structural elements of plastic moulds
- Material requirements for plastic m...
- Material selection of plastic mould
- Technical application of plastic mould
- Mold Development
- Injection mould
- The composition of the mould
- Five Rules Of Problem--Free Injecti...
- Plastic Injection Mold for Crate wi...
- China Plastic Mold/Tool Manufacture...
- Household Plastic Products Injectio...
- Household/Round Plastic Wash Basin ...
- Plastic Injection Mould for Home Ap...
- Aluminum Die Casting for Motorcycle...
- Precision mold of AOXU ·Continue to...
- How does Aoxu Mold run the project?
- Five rules of problem Free Injectio...